background image

3

INSTALL WALL SPOUT

12 

11

13

10 

ESCUTCHEON

O-RING

 

Remove PLASTER GUARDS and unthread ROUGH-IN NIPPLE 

(1)

.

Inspect that SPOUT NIPPLE O-RINGS 

(2 & 3)

 are seated in the grooves

of SPOUT NIPPLE 

(4)

. See Figure A.

Thread SPOUT NIPPLE (4) into VALVE BODY 

(5)

. Tighten SPOUT NIPPLE 

(4)

 to VALVE BODY 

(5)

.

Thread ESCUTCHEON MOUNT 

(6)

 onto SPOUT NIPPLE 

(4)

 until it engages the O-RING 

(2)

.

Make sure ESCUTCHEON O-RING 

(7)

 is in place. Push the SPOUT ESCUTCHEON 

(8)

 onto

ESCUTCHEON MOUNT 

(6)

 until it seats against the internal stop. Tighten SET SCREW 

(9)

with HEX WRENCH 

(12)

 supplied.

Thread ESCUTCHEON 

(8)

 flush against finished wall. SET SCREWS 

(9 & 11)

 should point

down toward the floor after tightening.
Push SPOUT 

(10)

 with SPOUT O-RINGS 

(13)

 into ESCUTCHEON 

(8)

 until seated

against stop. Align SPOUT 

(10)

 and tighten SPOUT

SET SCREW 

(11)

 with HEX WRENCH 

(12)

 supplied.

   

Figure A

4

INSTALL HANDLES

H 9 6 5 1 3 4 D

Wall Mount Lavatory Faucet

Install SPRING CLIP 

(1)

 onto VALVE STEM 

(2)

 as illustrated.

Slide BARREL SLEEVE WASHER 

(3)

 onto VALVE STEM 

(2)

 against SPRING CLIP 

(1)

.

Note: BARREL SLEEVE WASHER 

(3) 

is not supplied with Cross Handles. 

Slide ESCUTCHEON 

(4) 

onto BARREL SLEEVE 

(5)

.

7A 

Turn VALVE STEM 

(2)

 to off position. Align HANDLES as shown or as desired and install

HANDLE ASSEMBLY 

(7, 7A)

 onto VALVE STEM 

(2)

. Thread BARREL SLEEVE 

(5)

onto VALVE BODY 

(6)

 until seated tightly against valve.

Slide ESCUTCHEON 

(4)

 on BARREL SLEEVE 

(5)

 flush against finished wall. 

Отзывы: