INITIAL STARTUP AND ADJUSTMENT
The air for combustion and ventilation is supplied
through the front of the cooktop. The air is
exhausted upward. Do not obstruct the flow of
combustion and ventilation air.
Before startup, make sure that the cooktop has
been carefully checked for gas leaks and that it has
been properly connected to electric power.
Sealed Burners
The sealed burners are in sets of two. The right
burner knob controls the front burner and the left
knob controls the rear. To ignite the gas at the
burner, push knob in and turn knob to LITE-SIM.
You will hear a clicking sound indicating the proper
operation of the spark igniter. After the air in the
supply line has been purged, the gas should ignite
at the burner. After ignition, turn knob to desired
setting. The clicking sound should stop.
IMPORTANT: It is mandatory that the
ventilating hood, if installed, be turned
on and remain “ON” while burners are
operating.
PLEASE REMEMBER: These burners produce
a lot of heat at the HI setting. DO NOT
OPERATE THE BURNERS WITHOUT
COOKWARE ON THE GRATES. THE
PORCELAIN ON THE GRATES MAY CHIP
IF BURNERS OPERATE FOR AN
EXTENDED PERIOD OF TIME WITHOUT
COOKWARE ON GRATES.
The burners are tested and adjusted at the factory
prior to shipping cooktop. Adjustment is not
required on burners.
CHARBROILER
Similar to the open top burners, the
charbroiler uses spark ignition. To light
burner, push knob in, turn knob to HI and then
turn to LITE. To adjust burner flames, turn air
shutters. The burner flames should be blue
with 1/2” high distinct cones. It is normal that
during initial startup and when the knob is set
on HI, the first inch of the ports is not lit.
After the burners have established and
warmed up, the front ports will stay lit.
GRIDDLE
The griddle uses a glowbar ignition system. To
light the griddle burner, turn power switch on.
Push and turn griddle thermostat to desired
setting. The glowbar igniter will glow and in
20 seconds the griddle burner will ignite. The
burner flames should be blue with distinct
cones 1/2” to 3/4” high. To adjust burner
flames, loosen air shutter screw and turn air
shutter.
9
1/2 to 3/4
1 / 2
Operation
operation
