©1999 Jacuzzi Whirlpool Bath P592000 8/13/04
Jacuzzi Whirlpool Bath
P.O. Box 702168, Dallas, TX 75370-2168
Service Support: Call (800) 288-4002
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of
this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product.
Jacuzzi Whirlpool Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Printed in the U.S.A.
Printed on Recycled Paper
Drain Information
A drain/overflow assembly, purchased separately
from the bath, must be installed on the bath, water
tested, and connected to the sanitary system of the
house. After opening the carton, inspect for damage and
verify that the kit is of the proper finish. If a Jacuzzi
Whirlpool Bath drain/overflow is being installed, note
that the waste flange, strainer, overflow cover and cover
screws are packaged in a separate package within the
kit to protect the trim finish. Follow the installation
instructions provided with the drain/overflow kit. After
the drain is fully installed, test for proper drainage. If the
unit does not drain properly, rectify this condition before
proceeding with the installation. Jacuzzi Whirlpool Bath
is not responsible for removal and or reinstallation costs.
NOTE: Watertight installation of the drain is the
installer's responsibility. Any occurrence of drain
leakage is excluded from the Jacuzzi Whirlpool Bath
warranty coverage of this product.
CAUTION: A nonflammable protective barrier must
be placed between soldering work and bath unit to
avoid possible damage to the bath.
Clean-Up After Installation
To avoid dulling and scratching the surface of the
bath, never use abrasive cleaners. A mild liquid deter-
gent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge.
Metal tools will scratch the surface. Spots left by plaster
or grout can be removed if lightly rubbed with detergent
on a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with
paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol).
Minor scratches which do not penetrate the color
finish can be removed by lightly sanding with 600-grit
wet/dry sandpaper. You can restore the glossy finish to
the acrylic surface of the bath with a special compound,
Meguiar's #10 Mirror Glaze. If that is not available, use
automotive rubbing compound followed by an applica-
tion of automotive paste wax.
Major scratches and gouges which penetrate the
acrylic surface will require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
Operation
For instructions, see owner’s manual.
6
