Important: Read complete instructions before beginning installation.
Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been made. Do
not lift the bath by the plumbing at any time; handle by the shell only.
Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect in the finish, do not
install the bath. Damage or defect to the finish claimed after the bath is installed is excluded from the warranty. Jacuzzi Whirlpool
Bath's responsibility for shipping damage ceases upon delivery of the products in good order to the carrier. Refer any claims for
damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packed with
the product.
All bath units are factory tested for proper operation and watertight connections prior to shipping. Note: Prior to installation,
the bath must be filled with water and operated to check for leaks that may have resulted from shipping damage or
mishandling. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been discovered, repaired, or avoided by
following this inspection and testing procedure.
2
Framing and Support
The optional drain/overflow of the bath extends below the bottom of the bath. Note that this requires a cutout in the floor.
The floor structure beneath the bath must be able to support a total weight of approximately 805 pounds (bath, water
and bather) or 60 pounds per square foot. If the subfloor is level, no other preparation is necessary. You can proceed to install
the bath. If the subfloor is not level, you MUST level the entire surface prior to installing the bath. The use of materials that shim
or provide a level installation are allowed provided the method used will insure a level bath that is supported from the bottom.
Materials that may be used are a floor leveling compound, mortar, plaster or minimal expansion structural foam having a density
of a minimum of 5 lbs./cubic ft.; however the bath must remain level in order for it to drain properly and the foam feet must make
full contact with the mortar, plaster or structural foam foundation. (The bath must be supported as outlined above.) Both sides of
a joint or splice of subfloor should be level to each other. When attaching baths with flanges to stud wall, use shims to fill any
gaps between the bath flange and studs.
The rim of the bath is not designed to support weight. If finish material is to overlap or contact the bath, the added weight must
be fully self-supporting.
The protective film liner inside the bath is used to prevent damage to the finish from shoes, tools, etc. during
installation. Before installation, remove liner to inspect for any defects, reapply and do not remove until final cleanup.
The bath unit should be installed after construction of the studwall and rough plumbing is in place. The bath may be installed
as a single unit or, if necessary, disassembled and installed in three sections.
It is important that the framed pocket be plumb and square and that the framing members be located as detailed in the framing
illustration. If the bath unit is to be installed in an existing bathroom studwall, additional studs must be added to the dimensions
shown.
HEADER ON EDGE
BLOCKING REQUIRED IF UNIT
IS INSTALLED IN SECTIONS
16"
33-1/4"
26"
32"
21"
83"
62"
25"
1x2
12"
60-1/4"
FRONT
OF DOUBLE STUDS
SUB-FLOOR
90º
12"
16"
FRAMING DETAILS (RIGHT HAND SHOWN)
12" x 4" DRAIN
CUT-OUT
90º
