Jacuzzi Premium J-315, Руководство пользователя

Страница: 18 / 56

Page 4
• Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. Do NoT oVERFILL.
IMPORTANT: Always fill your spa through the filter bucket after drain-
ing. Failure to do so may cause air to be trapped in either pump, pre-
venting the pump from circulating water. Remove the hose and replace
both filter cartridges.
3. Turn On Power
Turn on power to spa at the home’s circuit breaker. The heater and
filter/circulation pump will automatically activate. If the control panel
LCD flashes water temperature and “
COL ” or “ ICE ”, refer to page
36 for additional information.
4. Activate Jets Pump 1
Depress the JETS button on the control panel once to
activate jets pump #.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 2.0 “Water Quality Maintenance” (page
33) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3 ppm and 5 ppm. To
ensure healthy water conditions, always maintain a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual. If sanitizer levels cannot be stabilized, perform the decon-
tamination procedure steps 9-5 on page 5-7.
Note: the “decon-
tamination procedure” steps 9-15 should also be used after the spa
has been “Winterized” (section 11.7, page 32 ) or has been sitting
without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
• The LCD display on the control panel displays the actual tempera-
ture of the spa water. Press either the
COOLER (-) or WARMER (+)
button once to display the “set” temperature for 5 seconds. If you
want the water to heat to a different temperature,