Jacuzzi Premium J-315, Руководство пользователя

Страница: 20 / 63

20
4.0 Main Control Panel Functions
Panel Functions:
A. Heat Indicator: Lit when heater is on.
B.
Warmer Button:
Increases water tem-
perature setpoint.
C. Cooler Button: Decreases water temper-
ature setpoint.
D. LED Display: Can display current water
temperature (default display*), water tem-
perature setpoint, selected filtration mode,
and error messages.
E. Light Button: Turns underwater light in ran-
dom mode; then repeatedly press the light button to turn the light off or to select on of 6 constant colors.
F.
Jets 1 Button:
Turns pump 1 on and off as follows: Press once for low speed; a second time for high speed;
a third time to turn off.
G. Jets 2 Button (J-345 and J-335 only): turns pump 2 on and off as follows: Press once for high speed; a
second time to turn off.
Operation Details:
•
Temperature Adjustment: 65 to 104ºF (18 to 40ºC). Factory setting is 100ºF (38ºC).
• Underwater Light Operation: The light runs for 1 hour, then shuts off for increased bulb life.
• Jet Buttons Operations: The jets run for 20 minutes after activated then turn off automatically to conserve
energy. Simply press a Jet Button to continue operation for an additional 20 minutes.
4.1 Setting Filter Cycle Start Time
Two methods for setting the filter cycle start time are possible:
•
Turn power on to the hot tub two minutes prior to the desired filter cycle start time, or
• Press and hold both the Warmer and Cooler Buttons at the same time, then press and release the
Jet 1 Button to reset the control panel and start the power up sequence. During the power up sequence, the
previously set filter cycle setting and temperature setpoint will be maintained. To select another filter cycle
at this time, see section 4.2 below.
Example: If you desire your first filter cycle to begin at 10:00am, perform either of the above steps at 9:58am. Filter
cycle start time may vary slightly from the setpoint.
4.2 Programming Filter Cycles
Proper filtration is an important key to maintaining the clarity of your hot tubs water. The hot tubs filtration sys-
tem is designed for unsurpassed effectiveness at removing debris and suspended particles from the water anytime
the water is circulated by the pump.
To select a pre-programmed filter cycle or lockout mode, press and hold both the Warmer and Cooler
Buttons at the same time, then release. Then press either the Warmer or Cooler Buttons to select either
filter mode FØ through L2 as illustrated on the following page.
104
A
B
C
D
E
F
G
*Display shown for example purposes only, actual
water temperature display will vary.