Jacuzzi Platinum 2001, Руководство пользователя

Страница: 18 / 52

Installation
5. On initial start-up, it is recommended to purge and sanitize the system as stated below.
- Remove the hot tub cover completely.
- Close the drain valve on the suction plumbing.
- Fill the hot tub with water through the filler housing to its normal level, which is to the
water level indicator mark on the skimmer frame.
- Turn ON the circuit breakers at the main electrical panel.
- At the control panel on the hot tub rim, press the JETS button twice for maximum jet
action.
- Add 1/2 cup sodium dichlor (a fast dissolving granular type of chlorine) to the water and
run for 30 minutes.
- Turn OFF the circuit breakers.
- Immediately open the drain valve and drain the hot tub completely.
CAUTION: Leave the optional cover OFF the hot tub during this procedure. DO
NOT use the hot tub during this procedure. Drain the hot tub immediately
afterword.
6. Close the drain valve and fill the hot tub with water (approximately 7 inches below the hot
tub rim) to the water line indicator on the skimmer frame.
7. Turn ON circuit breakers at the main panel.
8. Test the hot tub for proper operation. (Refer to Operating Instructions.)
9. Add 4 tablespoons of chlorine to the water.
10. Refer to Water Quality section of the Operating Instructions. Test for water quality and
then add treatment chemicals as necessary to ensure proper water quality levels.
All Jacuzzi Premium spas are factory tested for proper operation and water tight connections
prior to shipment. If leaks or other malfunctions are detected, immediately notify your Jacuzzi
Premium Spas dealer or Authorized Service Agent.
Page 14
NOTE: Never fill with water from a water softener. If your water is extremely “hard”, it is
preferable to fill it half way with hard water and the rest of the way with softened water.
Or, you may fill entirely with hard water if you use a special water additive available
from your Jacuzzi Premium Spas dealer or service organization.