Jacuzzi J-Sha Mi, Инструкция по сборке, использованию и обслуживанию

Страница: 33 / 136

33
Also, the programmes include a progressive increase in the inten-
sity and speed of movement of the dorsal jets. Therefore, any
modification to these values during the cycle (see below) takes
effect immediately, but is temporary. Afterwards, the values follow
the trend of the programme memorized in the computer.
(fig. 14) To start the function, check that the message I/O
is flashing and press the key. Make sure you are aiming
the remote control at the receiver on the edge of the tub. The
cycle will start and the LED on the receiver next to the
symbol will come on.
Once time has expired, the function stops automatically and
the receiver LED also goes off.
When running the cycle, you can modify the power of the
dorsal jets, the speed of movement and the duration, by plac-
ing the flashing cursor in the desired sector with the keys
or
and using the keys or :
- place the flashing cursor on the message SPEED to vary
the speed of movement of the dorsal jets (graphically
shown by an animated "ladder").
- Place the cursor on the message INTENS. to vary, in the
same way, the power of the jets (graphically shown by an
animated "ladder").
In fig. 15 there are diagrams showing the three “BackJet”
cycles pre-set in the factory, and the effect of any modifi-
cations made during while the cycle is running.
- the message TIME , represents the duration of a cycle (from
a minimum of one minute to a maximum of thirty minutes) .
This value can be varied by placing the flashing cursor on the
message TIME and using the keys
or .
• All variations to the above values refer however to the facto-
ry pre-set programme you have selected (TONIC or RELAX)
and can be carried out only when the “Back Jet” function is
active.
• If you want to pause the current function, move the cursor to
the message I/O and press the key. Make sure to aim the
remote control at the receiver on the edge of the tub (fig.12).
To start the function again from the point where it was sus-
pended, press the
key again.
NOTE
NOTE
If you want to change programmes (e.g. from TONIC to
RELAX) or change from the BACK JET cycle to BODY JET
or MIX, proceed as follows:
- aim the remote control at the receiver on the edge of the tub,
place the cursor on the message I/O (using the keys or
) and press the key .
- When the message starts flashing, press the key. The
display will show the screenshot as in fig. 12, where you can
select other hydromassage modes (refer to related chapters).
15'
40-60
50-70
60-100
18' 21'
TIME
INTENS.
TIME
(+)
INTENS.
TIME
(+)
(—)
INTENS.
INTENS.
TIME
(—)
15