44
Radio
(optional)
I
Turn on the remote control by pressing the key
: The dis-
play will show the Jacuzzi logo and moving bubbles.
Turning on the radio
I
(fig. 28) Then press the key
: The display will show an
icon for the radio function, with the cursor flashing on the mes-
sage
I/O
.
I
Make sure you are aiming the remote control at the receiver,
as shown in the figure, and press the key
. The radio will come
on, and it will show the last frequency it was tuned to.
•
If tuning is not possible when the radio is turned on, the dis-
play will show the message “NO RX”. Refer to the paragraph
on tuning.
•
If the remote control is not used for about 1 minute, the display
panel light gradually fades until it goes out; press any button to
start it again.
Adjusting the volume
I
Use the keys
or
respectively to increase or de-
crease the volume.
Frequency adjustment
I
(fig. 29) The radio includes an automatic system for search-
ing for transmitting stations. To activate it, proceed as follows:
- Use the keys
or
to place the flashing cursor on
SEEK
.
- Aim the remote control at the receiver and do the following:
• press the
key to start searching for stations that are
broadcasting on frequencies that are higher than the one
currently in use.
• press the
key to go back to the frequency immedi-
ately previous to the one currently in use.
Frequency memorization
I
(fig. 30) It is possible to memorize 3 different frequencies
by doing the following:
NOTE
1
3
2
3
40
°
C
16:30
40
°
C
16:30
MEM 3
MEM 2
MEM 1
SEEK
103
VOLUME
2 3
40
°
C
16:30
MEM 3
MEM 2
MEM 1
SEEK
103
VOLUME
1
2
1
28
29