1. Make sure electric power is off at main breaker.
2. Static test water supply hoses for leaks.
3. Plug power cord into GFCI protected wall outlet.
4. Move the assembled J-Dream II into final position.
5. Connect 2" shower drain (see page 10).
6. Swing the hinged right hand equipment seat wall open (steps A, B, C below) to connect
the 3/4" diameter flexible copper steamer/reservoir drain line (refer also page 22).
A. Remove (3) screws E along door frame post (see page 18)
B. Remove (4) hex head bolts along seat wall (see page 12 or 13)
C. Swing seat wall with panel towards back wall
Close seat wall, reinstall fasteners, continue with step 7.
23
7. Adjust the levelling screws in the J-Dream II base feet and lock them in position.
8. Recheck fit of drain plumbing.
9. Secure J-Dream II in position using clamps provided as shown.
10. Connect showerhead hoses to wall outlets, snap drain cover into place.
Front
Back Wall
Adjustable foot
Floor clamp
Lag bolt
Secure J-Dream II in position on
floor using clamps (provided) on
two front feet.
Velcro
®
J-Dream II Owner's Manual
