20
Use cable ties to attach color coded hoses to back wall. The cable tie will have to be threaded
through the two holes in the back wall on both sides (ten places). The hoses are marked to
indicate where they are to be tied on the left side of the back wall. This is to allow the proper
slack when the hinged seat wall is swung open (like a door) to access equipment. In the center
of the back wall, thread the cable ties through the pre-installed cable tie mounts. The hot and
cold water lines are to go behind the steam line (after cable tieing to back wall) and under the
hose coded orange. Connect lines A, B, and C at the corresponding letters on the mixer. Also
connect hot and cold water supply hoses. Connect control cable. Connect ground wire (yellow
with green stripe) to terminal on mixer valve. Attach steam line to steam head.
CD/Radio
wire bundle
(tie wrapped
together with
hose)
C
A
B
Cable tie (feed through
two holes in back wall,
5 places each side)
Mark on hose - attach
to backwall with cable
tie at this point
Hose
A
C
B
Red
Green
Blue
Yellow
Orange
Steam Line (with black insulation cover)
Important: This line is to be routed in
such a way that it travels up from the
steamer (see page 22) and down to the
steam head. It cannot have any low
spots or kinks.
Hot Water Line
Cold Water Line
Line A (with braided
metal sheathing)
Control
Cable
Line B (use hot
water to ease
connection)
Line C (use hot
water to soften
the hose to ease
installation over
the barbed fitting)
Wire from seat wall to be
clipped to mixer here
Steam Head Fitting
J-Dream II Owner's Manual
