40
thread from mating wall fitting.
E.
Lift unthreaded filter cartridge from skimmer well.
F.
Rinse debris from filter pleats on each cartridge using a garden
hose and high pressure nozzle. Start at the top and work down-
ward towards handle. Repeat until all pleats are clean.
G.
Submerge both filter cartridges in spa. Tilt threaded end up-
ward to removed trapped air bubbles, then keep cartridges sub-
merged to prevent air entrapment during installation (step H).
H
I
J
(Filter Cover Back View)
H.
Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into wall fitting.
DO NOT OVERTIGHTEN!
I.
Install clean skimmer bag back onto the filter cover clips as
shown.
H.
Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into the wall fit-
ting. Do not over tighten.
I.
Install clean skimmer bag back onto the filter cover clips as
shown.
J.
Tilt filter cover back then gently press down to latch against
retaining clips.
L.
Turn power to spa back on.
Note: the main filter has a grid.
Periodically, the filter cartridge will need a more thorough
cleaning to remove imbedded oils and minerals.
For this, we suggest cleaning followed by soaking the filter
overnight in a plastic container filled with a solution of water and
specially formulated filter cleanser available from your author-
ized Jacuzzi dealer.
The average life expectancy of each filter is approximately two
years with proper care and water quality maintenance.
The replacement cartridges can be purchased from your trusted
Jacuzzi® retailer.
Draining and Refilling
About every 3 months, you will want to replace the spa’s water.
The frequency depends on a number of variables including the
amount of use, attention paid to water quality maintenance, etc.
You will know it is time for a change when you cannot control
sudsing and/or you can no longer get the normal feel or sparkle
to the water even though the key water balance measurements
are all within the proper parameters.
CAUTION! READ THIS BEFORE DRAINING: To prevent dam-
age to the spa’s components, turn off power to the spa at
the circuit breaker before draining it. Do not turn the power
back on until your spa has been refilled.
There are certain precautions to keep in mind when draining your
spa. If it is extremely cold, and the spa is outdoors, freezing could
occur in the lines or the equipment, see “WINTERIZING”.
To drain your spa, perform the following steps:
1. Turn off power to spa at breaker.
2.
3.
4.
5.
2.
3.
4.
5.
2.
Identify the drain valve, from the front, on the lower part of the
support base. Hold the rear ring nut still to stop it from turning,
then loosen and remove the front cap to expose the underlying
male pipe thread.
3.
Attach a garden hose to the exposed threads.
4.
Gently rotate the larger (rear) valve body 1/3 turn counter-
clockwise to unlock the drain valve.
5.
Pull the larger (rear) body outward to open drain.
6.
After the spa drains, perform steps 2-5 in reverse order to close
the drain prior to refilling the spa.
7.
Once the hot tub has been filled, turn it on and follow the in-
structions for filling (see the relevant section).
N.B.:
Always fill your spa through both filter wall fittings.
Cleaning The Spa Interior
To preserve the sheen of your spa’s surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical ef-
fect on the surface. If you are not certain as to the suitability of a par-
ticular cleanser, consult your authorized Jacuzzi dealer. Regardless
of the cleanser used, use extreme care to assure that no soap residue
Содержание J-300 Series
Страница 2: ......
Страница 3: ...Italiano Avvertenze 4 5 English Warnings 27 28 Fran ais Recommandations 48 49...
Страница 74: ...74...
Страница 75: ...75...