Jacuzzi frame 100, Использование и обслуживание

Страница: 50 / 196

50
X
Press the “note” key until the following appears on the dis-
play (the value “23” is an example):
P2=00
P1= 23
X
Make sure that the “P1” parameter has been selected and ad-
just the contrast using the keys “<” and/or “>”.
X
Press the “on/off” key to store the selected value.
The “P2” parameter will then be displayed: press the “on/off” key
again to confirm the displayed value.
Never modify the value of the “P2” parameter.
X
At this point, press the “on/off” key again to activate the elec-
tronic functions (refer to the relative chapter).

If after pressing the “on/off” key a few codes appear on the
display (AL_...), this means there is an error (refer to the “Errors”
chapter).
Errors
Before using the shower unit, always check the type
of error (see the
“Error conditions” chapter) and contact
the Jacuzzi® Service Centre if necessary.
Q
TOP model
The display shows one or more codes:
AL1_1
AL1_2
AL3
....
X
Press the “on/off” key again to activate the electronic func-
tions (“awaiting instructions” mode - refer to the “Activating the
electronic functions” chapter).
Q
TT model
Some LEDs and/or keys flash, in various combinations:
X
Press the “alarm” key to activate the electronic functions
(“awaiting instructions” mode - refer to the “Activating the electron-
ic functions” chapter).
Activating the electronic functions
"Awaiting instructions” mode
X
After checking for errors, or after pressing the “on/off” key
(TOP model) or any key (TT model) after the initial shower unit
activation phase
the “awaiting instructions" mode will be ac-
tivated , and it will be possible to activate the electronic func-
tions (refer to the relative chapters) .
This mode occurs each time an electronic function is turned
off; the control panel shows the keys and displays brightly il-
luminated (white light)
.
TOP model
TT model
X
If no key is pressed for a few seconds, the control panel will
switch to “stand-by” mode (see following paragraph).