www
|
jacques.com.au
Document Number
|
JED-0492
Revision
|
1.0
Page 12 of 18
1)
The relay output may only be connected to an ES1 or a SELV circuit! An ES1 circuit as per IEC/EN/UL 62368-1 or a SELV circuit as per
IEC/EN 60950-1 must be separated safely from a dangerous electrical circuit (e.g. 230 V or 110 V mains power), e.g. by means of double
insulation. The ES1 or SELV circuit must not exceed 60 VDC or 42.4 VAC
peak
(30 VAC
eff
)!
SAFETY WARNINGS
•
Observe the country-specific standards for installation, mounting and configuration.
•
Only use Jacques accessories that comply with the
product’s technical specifications.
•
Disconnect the Ethernet cable for any maintenance of the device.
•
Do not make any modifications to the device.
•
All external connected circuits shall fulfil the requirements for Electrical Energy Source Class
1 (ES1) and Limited Power Source (LPS) according to IEC/EN 62368-1.
INSTALLATION INSTRUCTIONS
•
See
Mounting Solutions
for methods of mounting a JIB product.
•
Jacques JIB and optional accessories shall be installed or replaced by trained and qualified
personnel only.
•
Before attempting to install please ensure your package contains the list of specified parts.
•
Do not install the device
on unstable walls or on surfaces which cannot support the device’s
weight.
•
Make sure the surface mount kit not subject to torsional forces (e.g. on uneven walls).
•
Avoid mounting unit in direct sunlight.
•
Connect a network cable into the RJ45 connection located on the front of the product which
can also be connected to an IEEE 802.3af PoE PSE compliant network switch or
management device.
•
Before powering the device, ensure all cables are correctly connected and not damaged.
