Jacobsen Standing Zero Turn Rotary Mower SZT 2648, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 39 / 60

MAINTENANCE 9
en-38
9.4 ENGINE AIR FILTER _______________________________________________________
Do not remove the elements to inspect or clean. Removal of
the filter that is not necessary increases the risk of dust and
other particles to enter the engine.
Clean or replace the outer filter element every 100 hours.
Replace the inner-safety element every third change of the
outer filter.
When service is needed, first clean the outside of the filter
housing, then remove the outer element. Only remove the
inner-safety element if replacement is needed.
Clean the inside of the filter housing. Make sure dust and other particles do not get into the engine inlet hose.
Inspect the new elements. Do not use a damaged element and never use an incorrect element.
Assemble the inner and outer filter elements. Make sure the elements seat correctly.
Assemble the cap to the filter housing. Make sure the cap seals around the filter housing. The dust valve on the cap
must be at the bottom of the filter. Fasten the cap with the two clips.
Check the air filter hoses for wear or damage. Make sure the hose clamps are tight and hold the hoses in position.
9.5 FUEL ____________________________________________________________________
Gasoline is flammable. Use caution when you add the fuel to the mower. Only use an approved container. The
spout on the container must fit inside the fuel filler neck. Never use the containers that are not approved to keep or
transfer fuel.
Fill the fuel tank to the bottom of the filler neck.
Do not use premium gasoline or an oil-gasoline mixture. Use clean, fresh, regular unleaded gasoline, 85 octane
minimum. When using blended fuel, do not use a blend with more than 10% ethanol. Under no circumstances should
you use a blend with methanol. Refer to the engine’s operator manual for fuel recommendations when using blended
fuel.
Check fuel hoses and clamps every 50 hours. Replace fuel hoses and clamps at first indication of wear or damage.
Keep fuel according to your local, state or federal regulations and instructions from your fuel supplier.
Never allow the tank to become empty. The level of fuel is shown on the gauge.
WARNING
Refuel the mower before you start the engine. When the engine is in operation or while the engine is hot, never
remove the fuel cap or add fuel to the mower.
Refuel outdoors only and do not smoke when you add fuel.
If the fuel spills, do not try to start the engine, but move the mower away from the area. Until fuel vapors are
removed, do not allow the sparks, open flame or other types of ignition.
Never keep fuel containers near an open flame or any device that can cause the ignition of fuel or fuel vapors.
Always tighten the fuel tank cap and container cap after you add fuel.
Valve
Cap
Outer
Element
Inner
Element
!