6 OPERATION
33
6.8 MOWING_________________________________________________________________
To mow:
1.
If side deck transport locks are engaged, release
them. See Section 6.6.
2.
Set mower to 4WD (L). Cutting units will not operate
in 2WD.
3.
Press deck levers (O) forward to lower decks.
Engage power take-off (Y) to start blades and
depress traction pedal slowly to begin mowing.
The correct operating speed depends on the height,
density, type of grass and terrain being cut.
NOTE: Engine speed will automatically decrease to 2400
RPM when PTO switch is engaged.
4.
To raise decks first turn PTO switch (Y) off to stop
blades, then pull and hold deck levers (O) back.
Always stop and raise decks when crossing paths or
roadways.
5.
Use turn assist pedals to reduce turning radius
when needed to cut around objects. See Section
5.2.
6.
Adjust down pressure control (P) as desired to
improve weight distribution between decks and
mower. See Section 5.3.
7.
Plan your cutting pattern to avoid unnecessary turns
so you will mow as straight as possible.
a.
For extremely tall grass, first cut at a higher level
then lower decks to the desired cutting height.
b.
Slow down when turning, operating in tight
areas, mowing on hillsides or over rough terrain.
6.9
MOW SPEED _____________________________________________________________
Cutting quality is better at speeds well below the
transport speed of the mower. An initial mow speed of 5
to 6 mph (8 to 9.6 kph) is set at the factory and should be
satisfactory for most cutting conditions. Local turf
conditions however may respond better to a different
speed.
To set mow speed, loosen jam nut (A) and adjust stop
screw up to reduce speed, down to increase speed.
Tighten nut to hold adjustment in place.
6.10 AFTER OPERATION _______________________________________________________
1.
Park the mower on a flat, level surface. Fully lower
the implements to the ground, engage parking brake,
stop the engine, and remove key from ignition switch.
2.
Grease and lubricate all points if required, wash the
cutting units and mower after each use.
Note: Do not wash a hot or running engine. Use
compressed air to clean the engine and radiator fins.
3.
Fill the fuel tank with fresh, clean fuel. Be sure to
reinstall and tighten fuel cap.
WARNING
To prevent serious injuries, keep hands, feet, and
clothing away from cutting unit when the blades are
moving.
NEVER use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
can be sharp and could cause injuries.
To clear obstructions from cutting unit, disengage
power take-off, engage parking brake, stop engine,
and remove key from ignition switch then remove
obstruction.
!
CAUTION
Never raise decks with the blades turning. Always
disengage power take-off.
!
A
HR026
Содержание HR 9016 Turbo
Страница 18: ...3 DECALS 17...
Страница 53: ...ADJUSTMENTS 9 52 Figure 9D K J H G G...
Страница 69: ...NOTES 12 68 12 NOTES...
