Jacobsen Fairway 405 Series, Руководство по обслуживанию

Страница: 19 / 60

GB-17
JACOBSEN 405 Series: CH
MAINTENANCE AND PARTS MANUAL
ADJUSTMENTS
6.2 REAR WHEEL TOE-IN
The rear wheels should toe in 3.2mm(1/8") from the
front to the back of the wheel. (Fig.18)
1. Loosen locknuts D at rosejoints inside
each of the rear wheels.
2. For each wheel, rotate tie rod C until the
toe-in is correct.
3. Tighten locknuts D.
6.4 ALTERNATOR
The fan belt is adjusted so that it can be deflected
5mm (0.2in) with a force of 5 kg (11 lbs) applied
midway between the crankshaft and alternator
pulley. (Fig.19) To adjust:
1. Loosen alternator bolts A.
2. Move the alternator to tighten or loosen fan
belt.
3. Tighten bolts A.
6.1 SPEED LIMITER
The transport and mow speeds are factory set and
should not need altering.
NOTE : Textron Turf Care cannot be held responsible
for loss of performance or machine damage if these
speeds are adjusted outside the speeds shown in the
machine specification.
6.3 STEERING SHAFT
Casting B should just contact pin A on both sides.
(Fig.18)
1. Loosen nut F.
2. Verify steering balance by rotating steering
shaft G in its cylinder to produce full
steering right and left.
3. Tighten nut F.
Fig.18
Fig.19
6 ADJUTMENTS