Jacobsen ECLIPSE 360, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 72 / 148

B
en-72
Safety, Operation, & Maintenance Manual
ELECTRICAL SYSTEM
Lithium
PDU AND CONTROLLER LOCATIONS___________________________________
Power Distribution Unit (PDU) Circuit Breakers
Used to protect electrical system. Three manual reset circuit breakers located on the PDU are accessible by opening the
hood and looking towards the left ROPS post. Push down on rubber boot to reset circuit breaker.
Main Controller Unit (MCU) Diagnostic Lights
Twenty four lights are used to indicate active MCU functions. Lift MCU access panel to access MCU.
Reel Controller Unit (RCU) Diagnostic Lights
Eighteen lights are used to indicate active RCU functions. Remove access plug from right side of steering column to view
RCU diagnostic lights.
Braking Resistor Controller (BRC)
Remove right side operator platform cover to access BRC.
Traction Controller Diagnostic Light
Single green light on traction controller indicates power and faults. A steady light indicates the controller is active. A flash -
ing light indicates a traction system fault/error has occurred. Remove right side operator platform cover to access traction
controller.
Steering Controller Diagnostic Light
Single green light on steering controller indicates power and faults. A steady light indicates the controller is active. A
flashing light indicates a steering system fault/error has occurred. Open the hood and remove controller cover to access
the steering controller.
3WD Controller Diagnostic Light
Single green light on 3WD controller indicates power and faults. A steady light indicates the controller is active. A flashing
light indicates a 3WD system fault/error has occurred. Open the hood and remove controller cover to access the 3WD
controller.
3WD Controller
(3WD)
Located at the rear of the unit below the hood. 3WD controller is used to control the
rear wheel motor. The 3WD controller has one green light for diagnostics.
Controller Location/Function