en-48
6 OPERATION
6.3
PROCEDURE FOR OPERATION __________________________________________
1.
You must not start the engine without the operator in the seat on the tractor.
2.
Do not operate the mower and attachments with loose or damaged components.
3.
First cut in a test area so that you completely understand the operation of the mower and controls.
4.
Inspect the area and find the safest procedure for the vehicle. Check the height of the grass, the type of
terrain and the condition of the surface. Each area condition needs the applicable adjustments and
precautions.
5.
You must not direct the cut material toward persons near the machine. When the vehicle is in operation,
do not allow persons to stand near to the machine. The owner/operator maybe responsible for injuries
caused to persons near the machine and any damage to their property.
6.
Be careful when you cut surfaces that are near to gravel areas, roadway, parking areas, cart paths.
Stones released from the equipment can cause injuries to persons and damage the equipment.
7.
When you move across the roads or paths, disengage the cutting motors and lift the equipment. Check
for the traffic when you drive on the roads.
8.
If you hit an obstruction or if the machine has a vibration that is not normal, stop and inspect the
equipment for damage immediately. Repair damaged equipment before operation is continued.
WARNING
This mower has a Roll Over Protection Structure (ROPS). Always wear the seat belt with the ROPS.
If the mower is overturning, hold the steering wheel. Do not try to move off the mower or leave the seat.
CAUTION
To prevent injury, always wear the safety glasses, protective footwear,
a hard hat and ear protection.
CAUTION
Remove all dangerous material from the area before you cut the grass.
Enter a new area carefully and always operate at speeds that allow you to control the mower safely.
CAUTION
Before you clean, adjust or repair this equipment, always disengage all drives and lower all equipment
to the ground. Engage the parking brake, stop the engine and remove the key from the ignition switch to
prevent injuries.
WARNING
DO NOT USE ON SLOPES MORE THAN 16°
Содержание AR331
