Jacobsen AR3 EF Series, Руководство по эксплуатации и обслуживанию

Страница: 47 / 148

en-47
JACOBSEN AR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
9.9 GENERAL INSTRUCTIONS
FOR GRAMMER SEATS
• The operating instructions must be read in
full before use.
• The operating instructions must be kept in
the vehicle and always be at hand.
• The driver’s seat may only be fitted,
serviced and repaired by specialist
personnel,
• In accordance with national regulations
and the vehicle manufacturer’s fitting
instructions.
• The national fitting regulations can be
obtained from GRAMMER or from
agencies of the company, or from the
vehicle manufacturer.
• A correctly functioning and individually
adjusted driver’s seat is essential to your
health.
• Take adequate care of your seat and
have it serviced regularly to ensure that it
functions correctly.
• The functional checks are to be carried
out at least as regularly as vehicle
services (see maintenance plan for
vehicle).
• These operating instructions should
always be kept with the driver’s seat. If
the seat is passed on to a third party, it
must be accompanied by the relevant
operating instructions.
Safety instructions
• If you need to connect cables to the
vehicle supply network, strictly observe
the following instructions:
• Before you connect a seat switch, seat
heater or compressor, you must obtain
the relevant electrical data for the
respective vehicle with reference to
voltage, protection and the kind of
connections from the manufacturer, from
C D r o s s e r p m o C
/ t a e H t a e S
r o s s e r p m o C
V 2 1 A 0 1 A 0 2
V 4 2 A 0 1 A 5 1
V 8 4 A 0 1 A 0 1
y t i c a p a C g n i y r r a C t n e r r u C - h c t i w S t a e S
C D V 2 1 ) . n i m ( A m 0 1
C D V 0 5 2 ) . x a m ( A 5
GRAMMER or the company’s agencies.
• For safety reasons, the installation and
connection to the vehicle supply network
must be carried out by authorized
specialist personnel only.
• The seat connections must be protected
independently of other vehicle
components.
Notes Concerning Seat Switch:
Minimum and maximum current carrying capacity
for
purely resistive load.
In case of inductive or capacitive load, the
manufacturer must install a protective circuit
breaker for the consumers in the vehicle. If there
are any uncertainties, please ask the vehicle
manufacturer before making connections.
Driver’s seats that have been adjusted incorrectly
have a smaller moving area. To prevent damage to
the driver’s back and to the seat, the seat must be
adjusted for the driver’s weight before use and
before every change of driver.
To prevent injury, no objects should be placed
within the moving area of the driver’s seat.
Before commissioning of the driver’s seat,
possible packaging material has to be
removed from the seat cushion and the backrest
upholstery.
To eliminate any risk of accident, the settings must
be checked to ensure they are correctly engaged
before the vehicle is driven.
Adjustments must not be made while driving.
After removal of the backrest upholstery, the
backrest frame must be supported, for example
held in place, before the backrest adjuster is
operated. If you fail to do so, there is a danger that
the backrest frame may jerk forward and cause
injury.
Any changes to the series standard of the seat
(for example fitting parts which are not original
GRAMMER parts) may impair the safety standard
to which it has been tested.
Functions my be impaired, threatening your
safety For this reason, any changes in design of
the seat must be approved by GRAMMER.
During the removal and installation of the driver’s
seat, the corresponding instructions by
the specific vehicle manufacturer must be strictly
observed!
9 ADJUSTMENTS