Jacobsen 69168 - Turfcat T628D, Руководство по запасным частям и обслуживанию

Страница: 22 / 148

4 MAINTENANCE
en-22
4.20 STORAGE ________________________________________________________________
General
1. Wash the trac tor thoroughly and lubricate. Repair and
paint damaged or exposed metal.
2. Inspect the trac tor, tighten al l hardware, r eplace worn
or damaged components.
3. Drain and refill radiator.
4. Clean the tires thoroughly and store the tractor so the
load is off the tires. If tractor is not on j ack stands,
check tires at regular interv als and reinfl ate as
necessary.
5. Keep the machine and al l its accessories clean, dry
and protected from the elements during storage. Never
store equipment near an open flame or s park which
could ignite fuel or fuel vapors.
Battery
1. Remove, clean and store battery in upright position in a
cool, dry place.
2. Check and recharge battery every 60 to 90 days while
in storage.
3. Store batteries in a c ool, dry place. To reduce the self
discharge rate, room temperatur e should not be above
80°F (27°C) or fall below 20°F (- 7°C) to prev ent
electrolyte from freezing.
Engine (General)
1. While the engine is warm, remove the drain plug, drain
the oil from the crankcase and change oil filter. Install
drain plug and refill with fresh oil. Let engine cool before
storing.
2. Clean exterior of engine. Paint exposed metal, or apply
a light coat of rust preventative oil.
3. Add a fu el conditioner or biocide to p revent gelling
or bacterial growth in fuel. See your local fuel
supplier.
Cutting Units
1. Wash the cutting units thoroughly, then repair and paint
any damaged or exposed metal.
2. Lubricate all fittings and friction points.
3. Apply a l ight coat of r ust preventative oil to the
sharpened edges of the blades.
After Storage
1. Check and reinstall battery.
2. Check or service fuel filter and air cleaner.
3. Check the radiator coolant level.
4. Check oil level in the engine crankcase and hydraulic
system.
5. Fill the fuel tank with fresh fuel. O pen fuel s hut off
valve and bleed the fuel system.
6. Make certain that the tires are properly inflated.
7. Remove all oi l from the r eels and bedk nife. Adjust
bedknife and cutting height.
8. Start and operate the engine at 1/2 throttle. Allow
enough time for the engine to become properly
warmed and lubricated.
CAUTION
To prevent personal injury and damage to the cutting
edges, handle the blades with extreme care.
WARNING
Never operate the engine without proper ventilation;
exhaust fumes can be fatal when inhaled.
!
!