Jacobsen 69168 - Turfcat T628D, Руководство по запасным частям и обслуживанию

Страница: 14 / 148

4 MAINTENANCE
en-14
4 MAINTENANCE
4.1 GENERAL ________________________________________________________________
1. Adjustment and maintenance should always be
performed by a qualified technician. If proper
adjustments cannot be made, contact an Authorized
Jacobsen Dealer.
2. Inspect the equipment on a regular basis, establish
a maintenance schedule, and keep detailed records.
a. Keep the equipment clean.
b. Keep all moving parts properly adjusted and
lubricated.
c. Replace worn or damaged parts before operating
the machine.
d. Keep all fluids at their proper levels.
e. Keep shields in place and all hardware securely
fastened.
f. Keep tires properly inflated.
3. Long hair, jewelry or loose fitting clothing may get
tangled in moving parts.
4. Use the il lustrations in the Parts Catalog as
reference for the di sassembly and reassembly of
components.
5. Recycle or dispose of al l hazardous materials
(batteries, fuel, lubricants, anti-freeze, etc.)
according to federal, state, or local regulations.
4.2 ENGINE _________________________________________________________________
IMPORTANT: A separate Engine Manual, prepared by
the engine manufacturer, is supplied with this mower
.
Read the Engine Manual carefully until you are familiar
with the operation and maintenance of the engine.
Proper attention to the engine manufacturer’s
directions will assure maximum service life of the
engine. To order a replacement Engine Manual contact
the engine manufacturer.
The proper break-in of a ne w engine can make a
considerable difference to the performance and life of the
engine.
Note: The mower is designed to operate and cut most
efficiently at the preset governor setting. Do not change
the engine governor settings or overspeed the engine.
During the break-in period, Jacobsen recommends the
following:
1. During the first 50 hours of operation, a new engine
should be allowed to reach an operating temperature
of at least 140°F (60°C) prior to operation at full load.
2. Check the engine oil level twice daily during the first
50 hours of operation. Higher than normal oil
consumption is not uncommon during the i nitial
break-in period.
3. Change engine oil and oil filter element after first 50
hours of operation.
4. Check and adjust alternator belt.
5. Refer to
Section 6.3
and Engine Manual for specific
maintenance intervals.
If the injection pump, injectors, or the fuel system require
service, contact an authorized Jacobsen Dealer.
4.3 ENGINE OIL ______________________________________________________________
Check the engine oil at the start of each day, before
starting the engine. If the oil level is low, remove oil filler
cap, and add oil as required.
Perform initial oil change after first 50 hours of operation
and every 100 hours thereafter. See Engine Manual.
Use only engine oils with API classification CD/CE.
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine, and remove key
from ignition switch to prevent injuries
Make sure the mower is parked on a solid and level
surface. Never work on a mow er that is supported
only by the jack. Always use jack stands.
!
Above 77°F (25°C) SAE 30W or SAE10W30/10W40
32 to 77°F (0 to 25°C) SAE 20W or SAE 10W30/10W40
Below 32° (0°C)
SAE10W or SAE 10W30/10W40