4 OPERATION
18
4.8
MOWING SPEED __________________________________________________________
Cutting quality is better at speeds well below the transport
speed of the mower. An initial mow speed of 5 - 6 MPH (8 -
10 kph) is set at the factory and should be satisfactory for
most cutting conditions. Local turf conditions however may
respond better to a different speed. If an adjustment is
needed, refer to the
Parts & Maintenance
manual.
4.9
TOWING / TRAILERING _____________________________________________________
If the mower experiences problems and must be shut down
and removed from the area, it should be loaded onto a trailer
for transport. If a trailer is not available, the unit can be
towed slowly short distances.
Use care when loading and unloading mower. Fasten
mower to trailer to prevent mower from rolling or shifting
during transport.
Before towing, open tow valve. The tow valve permits
moving the mower without starting the engine and prevents
possible damage to hydraulic components.
The tow valve
(A)
is located on the hydraulic drive pump
beneath the operators seat. Remove cover from floor in front
of operator’s seat. To open valve, use a wrench or insert a
pin or small screw driver into the small hole in the valve
stem. Turn the valve counterclockwise one full turn.
Before towing make sure cutting units are raised. If they
cannot be raised, remove them from the mower.
Close valve completely and replace cover after towing.
Figure 4C
4.10 HILLSIDE OPERATION _____________________________________________________
The mower has been designed for good traction and stability
under normal mowing conditions; however, use caution
when operating on slopes, especially when the grass is wet.
Wet grass reduces traction and steering control.
1.
Always mow with the engine at full throttle but reduce
forward speed to maintain the proper cutting frequency.
2.
If the mower tends to slide or the tires begin to “mark”
the turf, angle mower into a less steep grade until
traction is regained or tire marking stops.
3.
If mower continues to slide or mark the turf, the grade
is too steep for safe operation. Do not make another
attempt to climb, and back down slowly.
4.
When descending a steep slope, always lower
implements to the ground to reduce the risk of mower
overturning.
Correct tire pressure is essential for maximum traction. See
Parts & Maintenance Manual
.
NOTICE
On machines equipped with four wheel drive (4WD) the
mower will tow easier if the ignition is turned to RUN (
do
not start engine
) and the 4WD switch is set to 4WD.
NOTICE
Do not exceed 2 MPH (3.2 KPH) while towing. Long
distance towing is not recommended
.
A
LF006
WARNING
To minimize the possibility of overturning, the safest
method for operating on hills and terraces is to travel up
and down the face of the slope (vertically), not across the
face (horizontally). Avoid unnecessary turns, travel at
reduced speeds, and stay alert for hidden hazards.
CAUTION
Do not operate this mower on slopes greater than
20°.
!
!
