5
15.Place key
(Item 20)
onto brush shaft.
16.Loosely assemble two set screws
(Item 23)
into brush
pulley
(Item 22)
.
17.Place belt
(Item 21)
over Turf Groomer pulley and
brush pulley
(Item 22)
. Slide brush pulley onto brush
shaft.
18.Use a straight edge to align pulleys and tighten set
screws
(Item 23)
.
19.Assemble 3/8-16 x 3/4” screw
(Item 14)
, lockwasher
(Item 15)
, and flat washer
(Item 24)
to end of brush
shaft.
20.Remove and discard 1/4” hardware
(E)
.
21.Loosely assemble 1/4-20 x 2” hex head screw
(Item
25)
, flat washer
(Item 30)
, front shield bracket
(Item
26)
, spacer
(Item 11)
, lockwasher
(Item 29)
, and nut
(Item 31)
.
22.Assemble belt shield
(Item 27)
to shield brackets using
two 1/4-20 x 3/4” hex head screws
(Item 28)
,
lockwashers
(Item 29)
, and flat washers
(Item 30)
.
23.Adjust belt shield and shield brackets as required to
provide even clearance for belt. Tighten hardware for
belt shield and shield brackets.
Figure 14
Figure 15
Brush Adjustment ______________________________________________________________
Brush should be adjusted so the bristles just touch the
roller an equal amount along the entire length of the roller.
Adjusting the brush too tight against the roller will result is
increased motor amperage and temperature, and will
shorten operating time for battery units.
To adjust brush:
1. Loosen hardware
(G)
and set screw
(H)
on both ends of
brush.
2. Turn eccentric nut
(F)
as required to obtain proper
adjustment. Repeat for opposite end of brush.
3. Tighten set screw
(H)
and hardware
(G)
.
14
15
1
8
19
20
21
22
2
3
2
3
24
25
26
27
2
8
2
8
29
29
3
0
3
0
29
3
0
3
1
E
E
11