3
ASSEMBLY INSTRUCTIONS —
CONTINUED
2. Spread both upright tubes apart and insert one end of the lower pipe hanger tube into
one of the lower slots with the hanger rods angled upward (see Figure 3A). Then, insert
the opposite end of the lower pipe hanger tube into the other upright tube’s lower slot.
Ensure the lower pipe hanger tube is fully inserted on both ends (see Figure 3B).
3. Install the upper pipe hanger tube by inserting the notch at both ends of the upper pipe
hanger tube into the top of the upright tubes until fully seated (see Figure 3C). Insert the
two locking retainer pins into the holes at the top of the upright tubes and secure.
LOWER PIPE
HANGER TUBE
LOWER SLOTS
UPRIGHT TUBE
LOWER PIPE HANGER
TUBE FULLY INSERTED
PIPE HANGER
TUBE NOTCH
UPRIGHT TUBE
LOCKING
RETAINER PIN
BASE
GRIP
COMPLETED
ASSEMBLY
UPPER PIPE
HANGER TUBE
HANGER ROD
Figure 3A
Figure 3B
Figure 3C
