DECK MOUNTING OF THE DISHMACHINE:
The dishmachine must be secured in place using the deck mounting tracks and caps
provided with machine. Install the (4) adjustable feet provided into screw holes where shipping bolts were removed earlier. Adjust
the level of the dishmachine by screwing the adjustable feet in or out. The front of the machine should be adjusted 1/4” to 1/2” high-
er than the back. Install the deck mounting hardware as shown in the drawing below, at the location where the dishmachine will be
permanently positioned. Install 3/8” stainless steel lug bolts to secure tracks and caps to the deck. Drill holes into deck as shown
below and insure rear holes are located 2-1/4” from the wall. The racks and rear end caps may be tightened at this time. Slide dish-
machine onto tracks and into position at rear end caps. Install front end caps into place and adjust if necessary to remove any
movement of machine; if possible, tack weld tracks to deck.
INSTALLATION INSTRUCTIONS (CONTINUED)
5
TYPICAL
LOCATION
OF FOOT
LEVELER
EXISTING WALL
19”
21 7/8”
21 1/4”
23 1/2”
2 1/4”
TOP VIEW
REAR
END CAPS
FRONT VIEW
19”
TYPICAL
LOCATION
OF FOOT
LEVELER
FRONT PANEL
OF DISHWASHER
21 7/8”
FLOOR
