Jackson Grills LS700BI-LP, Руководство пользователя

Страница: 15 / 24

15
Figure 12
Fuel Conversion:
This grill is convertible to Natural Gas or Propane when needed, with the installation of the appropriate Gas
Conversion Kit. (See parts list, Pg. 22) The kit should be installed by a qualified gas fitter. Please contact your
local dealer for information.
Grill Lighting Instructions:
1. BEFORE LIGHTING:

Always i
nspect the gas supply hose before turning the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced before use. Use only a manufacturer approved replacement hose.

Check all gas connections for leaks before each use. Do not light grill if gas odor is present.
2. TO LIGHT MAIN BURNERS OF THE GRILL: (see Fig. 10)

Read instructions before lighting (see labels on top edge of the pull out grease tray)

Open lid prior to lighting your grill.

Turn all knobs to
“OFF” then open the propane cylinder valve, OR natural gas valve on your gas
connection. NOTE: Always keep your face and body averted when lighting.

Push in and rotate each control knob counter clockwise slowly, to the high position . (When rotating
the knob, rotate for a two second count: do NOT turn the knob rapidly) The built-in igniter will click
and spark, thus lighting the torch light pilot flame, then the main burner. If the burner does not light
IMMEDIATELY turn the knob to off and wait 5 minutes for gas to dispel and repeat the lighting
procedure.

Follow match lighting instructions if burner can
’t be lit after repeating 3-4 times.
3. TO LIGHT MAIN BURNERS USING A MATCH OR BARBECUE LIGHTER:
(Temporary Solution when Ignition is disabled)

Read instructions before lighting.

Open the lid during lighting, and remove cook grids.

Turn all knobs to
“OFF” then open the propane cylinder valve, OR natural gas valve on your gas
connection. NOTE: Always keep your face and body averted when lighting.

A long stove match or BBQ lighter must be used to reach the burners.

Do NOT drop a burning match into grill for lighting purposes; hold the match in the desired spot.

Push and turn the main burner knob to the high position , then release.

Light burner by match at the front end of the burner tube. Make sure the burner lights and stays lit.

If necessary, call your dealer or the Jackson help line, for assistance with repairing your ignition system.
OFF setting
HIGH setting
& Ignition
LOW setting