Jackson Grills JPG50, Руководство пользователя

Страница: 2 / 13

1
!WARNING!
1. Do not store or use gasoline or
other flammable liquids or vapors in
the vicinity of this or any other
appliance.
2. An LP cylinder not connected for
use shall not be stored in the vicinity
of this or any other appliance.
!WARNING!
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from
the appliance and immediately call
your gas supplier or your fire
department
CERTIFICATION AND SAFETY
This appliance has been tested by LabTest Certification Inc. and has been tested to ANSI Z21.58-2007/
CSA 1.6-2007 + Addenda 1 (2008).
NOTE: The use and installation of this product must conform to local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI A223.1/NFPA S4, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling code, B149.2, or the Standard for
Recreational Vehicles, ANSI A 119.2/NFPA 1191, and CSA Z240 RV Series, Recreational Vehicle
Code, as applicable.
SAFETY FIRST:
Read and understand all warning and precautions prior to operating your portable gas grill.
DANGER:
To prevent fire or explosion hazard always perform a Leak Test.
1.
Always perform a “LEAK TEST” before lighting this portable gas grill, each time the cylinder
is connected for use.
2. NO SMOKING. Do not use or permit sources of ignition in the area while conducting a leak
test.
3. Conduct the leak test outdoors in a well ventilated area.
4. Do not use matches, lighters, or any open flame to perform a leak test.
TO CHECK FOR LEAKS:
Make 2 or 3 OZ. of leak solution by mixing 1 part liquid dish soap with three parts water.
1. Make sure the gas control knob is off.
2. Spoon several drops of this solution at the cylinder to the regulator valve connection.
3. Inspect the solution at the connection, looking for bubbles. If NO bubbles appear, the
connection is secure. If bubbles appear, you have a leak.
4. Disconnect the cylinder and reconnect, making sure the connection is secure.
5. Retest with soap solution, if you continue to see bubbles, replace the cylinder.