Jack JK-K4-UT, Руководство по эксплуатации и каталог запасных частей

Страница: 64 / 132

5/8
P 1 7 0~99 0
Automatic induction presser foot sensor setting (between the maximum and minimum
value of the 02C parameter display)
P 2 4 0~1024 150
Trimming point of pedal
P 2 7
0~3
1
Presser Foot sensor mode setting: 0: off 1: turn on only after trimming 2: always ON
P 3 0
0~31 0
Feedforward torque of motor: 0: normal functions 1-31: feedforward torque level
P 3 2 1~500 60 Encryption seam solenoid full open time (ms)
P 3 3 0~100 6 Encryption seam solenoid off time per cycle (ms)
P 3 7
0~100
5 Encryption seam solenoid on time per cycle (ms), means the clamp strength.
P 3 8
1~999
120 Flat seaming shear velocity (under the knife to maintain time) -- -- -- -- -- - under the knife
P 3 9
1~999
160
Scavenging action time delay -- -- -- -- -- -- -- -- -- -- on the knife (note: this is also flat
seaming machine cut line)
P 4 0
1~999
30
Duration and linear velocity (scan line) -- -- -- -- -- -- -- -- on the knife (note: this is also flat
seaming machine cut line)
P 4 1
0~9999
120 Blowing began to delay time(ms)
P 4 2
1~9999
300 Blowing duration(ms)
P 4 3
0~25
2 Sweep line, choice of blowing function (2 for scavenging; 8 for blowing)
P 4 5
0~100
1
Trimming electromagnet per cycle opening time (ms)
P 4 6
0~100
2
Trimming electromagnet per cycle closing time (ms)
P 4 9
100~500
300
Trimming Speed
P 5 0 1~500 100
Presser foot lifting electromagnet full output time ms
P 5 1 0~100 15
Presser foot lifting electromagnet per cycle opening time (ms)
P 5 2 1~800 150 Running delay time when presser footer comes down (ms)
P 5 3 0/1 1
Presser foot lifting function selection
0: off 1: on
P 5 4 0~100 35
Presser foot lifting electromagnet per cycle closing time (ms)
P 5 6 0/1 1
Run to up needle position after Power on
喚
0: no action 1: action
P 5 7 0~600 200
Presser foot lifting electromagnet protection time 100ms
P 6 0 200~5500 4000
The maximum speed of constant sewing (Automatic test speed)
P 6 2 0~4 0
Special mode:
0: normal Mode
1: simply sewing mode
2: motor initial angle measurement (Do not remove the belt)
3: Automatically setting the pulley ratio by the CPU. (Synchronizer is necessary and the
belt not removed)
4:
automatic test modle 1 (It has needle stop position of automatic test, running and
stopping 5S)
P 6 6 0/2 2
Safety switch function set: 0:off 2:on
P 7 1 0~50 0 Slow release lifter level adjustment, the smaller values and the faster quickly (OC open