MSH RHL DHSG AEI
Volume button
Visual indicator (red)
Link icon
Mute icon
Charge icon
–
+
Jabra Pro™ 9400
series
Jabra go™ 6470
or
or
Jabra gN9350e/
Jabra gN9330e eHs
Jabra gN9120/
jabra gN9125 eHs
7
electronic Hook switch (eHs) solutions for cisco
SuPPOrtEd cIScO IP PhONES
SEt uP INFOrmatION
To connect your Cisco Unified IP Phone and Jabra headset with the HHC Adapter, just follow these
simple steps:
Setting up the cisco unified IP Phone
Connect the large plug to the AUX port on the phone
1.
Connect the smaller plug to the AUX port on the headset base
2.
Connect the normal audio cable to the headset socket on the phone and the phone socket on
3.
the headset base.
cisco Unified iP Phone
7975g
cisco Unified iP Phone
7945g
cisco Unified iP Phone
7965g
cisco Unified iP Phone
7942g
cisco Unified iP Phone
7962g
For more information and disclaimer, visit www.jabra.com/cisco
regional sales contacts:
Americas: Bill Orlansky, [email protected]
EMEA:
Norbert Lohwieser, [email protected]
APAC:
Mike Powrie, [email protected]
see tHe Last Page for order iNfo
HHc requires cisco Unified communications manager 4.1 (3)
service release 6 or above plus the 8.3 (3) phone firmware load
Setting up Jabra PrO 9400 and Jabra GO
6400 - follow the guide on page 11.
Setting up Jabra GN9350e
Open up the cover on the base unit.
1.
On the LCD display, navigate to the
2.
handset picture.
Navigate to the DHSG mode and select
3.
it by pressing the OK button.
Set Compatibility selector in position “B”
4.
.
Setting up Jabra GN9330e EhS
Place headset on base station.
1.
Push simultaneously 5 sec on the 2
2.
buttons (base station and headset
– see illustrations next column)
LED on headset starts to blink rapidly
3.
Choose EHS mode with volume control
4.
on headset. LEDs on base indicates
selected mode: LED 2: DHSG mode
After setting wait a few seconds.
5.
When LED on headset stops blinking,
start using headset.
Note: Headset Hookswitch control must be enabled on each phone.
AUX
OLI
4/12
3/12
<
compatibility selector
Jabra gN9350e
Setting up Jabra GN9120/GN9125 EhS
Set compatibility selector (
1.
Telephone
Termination Switch Wheel) in position “A”
Set the base unit to the DHSG mode
2.
by keeping the headset in the base
and hold the /- buttons on
the headset for 6 seconds until the red
light on the base flashes rapidly.
Scroll through the four different
3.
settings using +/- and set to the lips
icon. Leave for 15 seconds until the
unit has displayed the confirmation
flash sequence and it is ready to go!
Jabra LiNk™ 14201-22 HHc adapter for cisco
Jabra LiNk™ 14201-16 HHc adapter for cisco
setting up Jabra gN9330e eHs
The Jabra Pro 9400 series, Jabra GO 6470, Jabra GN9300e series, Jabra GN9120 series, Jabra Link 14201-22
and Jabra Link 14201-16 have tested compatible with the listed Cisco Unified IP Phones.
