14
EN
g
LiS
h
Jabra A7010 Bluetooth hub
15
EN
g
Li
Sh
Jabra A7010 Bluetooth hub
4 foR USE WiTh dESk phoNE WiTh hEAdSET poRT
Some desk phones are equipped with a headset port, allowing a corded headset to be plugged in directly.
When using the headset port, the handset remains in its cradle, making headset use easier. Please refer to your
desk phone user manual for more information.
nOTE:
in the following pages, all references to “
Tap
the headset Answer/End button” refer to the action
needed for most common Jabra headsets available. yours may differ – please refer to your headset’s user
manual.
JAbRA A7010 SET Up
Connecting your Jabra a7010 with your desk phone and power supply
·
Connect the desk phone headset port to the Jabra A7010 desk phone socket (7) using the supplied
connection cord (desk phone-to-Bluetooth hub (C)).
·
Connect the power supply (B) to your Jabra A7010’s power supply socket (10).
·
Connect the power supply (B) to the wall power socket.
·
you can use the ‘wire guide’ at the bottom of the Jabra A7010 to neatly guide the cable from the desk
phone to the wall phone plug.
The green LED (2) indicates that the Jabra A7010’s power is on.
in the unlikely event that the Jabra a7010 is not OK, its LED (2) will flash red.
·
First, try disconnecting and reconnecting the Jabra A7010 to the power source.
if the LED (2) is still flashing red, you must reset your Jabra a7010.
·
Press and hold
the Jabra A7010 reset button (8).
·
The LED (2) will turn solid red for 3 seconds, and then turn green.
if the LED (2) is still flashing red after disconnect and reset, please contact your dealer.
imPORTanT:
Following reset, you must pair your
Jabra a7010
and headset.
how to pair your Jabra a7010 and headset
imPORTanT:
refer to your headset’s user manual for information about how to pair it to another device.
·
Set your headset into pairing mode according to its user manual.
·
Set your Jabra A7010 into pairing mode by
pressing and holding
its pairing button (3). The LED (2) will
show a steady blue light and the Jabra A7010 will ‘search’ for a headset.
