jablotron JA-63 PROFI", Руководство по установке, Страница: 4 / 17

JA-63 „PROFI“ Alarm System - 4 - MGK55401
This product should be installed by professional installers. The
manufacturer assumes no liability for damages caused by incorrect
installation or improper use of this system.
1 Architecture of the control panel
The JA-63 "Profi" is a fully programmable control panel with
building block architecture. By programming, it can be split into
two separately operated sections (with a shared section). It has
a built in power supply and there is ample space for a back up
battery (12V, 1.3Ah or 2.6Ah) in the control panel case.
The JA-63K main board has 4 hard-wired inputs with
programmable triggering (NC, balanced or double balanced) and
programmable reactions.
Model JA-63KR (equipped with the “R” radio communicating
module) has 16 wireless zones . Up to two JA-60 detectors can be
enrolled into each zone (totally 32 as a maximum). In total model
63KR has 20 zones (4 wired and 16 wireless). Up to 8 wireless
controllers (remote controls or wireless keypads), a JA-60A
wireless siren and unlimited number of UC family wireless output
modules can be enrolled as well. If more zones are required,
another JA-6x control panel can be enrolled as a subsystem
(Master & Slave architecture). The master control panel receives
information from the sub control panel and it can also arm and
disarm the subsystem panel.
Telephone module “X” can communicate with a Monitoring
Station, send two voice messages, send five SMS messages
via SMS server (or dial a numeric Pager). It can also
communicate with a remote PC (using ComLink SW and a JA-
60U modem).
GSM dialer JA-60GSM sends SMS messages, calls to
predefined telephone numbers and plays audible warning,
communicates with 2 CMS, allows remote access from a phone’s
keypad and can be set via web page.
Operation and programming is possible via the JA-60E
keypad. The control panel equipped with a radio module can
also be programmed and operated by a JA-60F wireless keypad
and can also be operated by RC-40, RC-22 or RC-60 remote
controls or by a JA-60D wireless keypad. Operation and
programming is also possible via a PC using PC-60A interface
and ComLink software.
the internal layout
Available models of the JA-63 system
control panel
R
module
X
module
GSM
module
description
JA-63K no no no four zone hard wired control panel
JA-63KR yes no no 16 zones wireless (up to 32 detectors) & 4 hard wired zones
JA-63KRX yes yes no
16 zones wireless (up to 32 detectors) & 4 hard wired zones & digital telephone
communicator.
JA-63KRG yes no yes 16 zones wireless (up to 32 detectors) & 4 hard wired zones & GSM dialer.
Note: Radio module R can not be ”aftermarket” installed into 63K and 63KX models. Telephone communicator X module and GSM dialer JA-60GSM can be installed
additionally to a 63K or 63KR control panels.
2 Control panel installation
•
The control panel should be easily accessible but not visible.
There should be a power socket available and also a
telephone line (if the system has an optional built in dialer).
•
Attach the control panel’s rear housing to the wall (see
drilling diagram on the last page of this manual).
•
Route all the cables to the control panel (power, input loops,
telephone line etc.) before you tighten the case to the
desired location.
Note : Only a qualified technician can provide the installation,
telephone line connection and servicing. User is not allowed to
open the cover and/or make any modification.