NEW TECHNOLOGY
OLD RELIABILITY
J.W. Davis & Company
• 3030 Canton Street • P.O. Box 710219 • Dallas, Texas 75371-0219
Sales 800-527-5705 • Fax 800-388-9106 • Corp 214-651-7341 • Fax 214-939-0328 • www.jwd.com • [email protected]
The Mark of the Professional...
Installation Guides
Use
INSIDE
diminisions of enclosed template to mark the cutout
for the speaker. (Tip: Check top of the cutout with a carpenter’s
level to ensure correct vertical alignment.)
Carefully remove grille using small flat-blade screwdriver to slowly
pry up one corner to access the mouting screws.
Connect incoming 70 Volt line to the spring-clip terminal, taking
care to maintain correct polarity. (Red 70V, Black Com).
Turn all 6 rotating wall clamps inward and put speaker in cutout
space.
Using phillips screwdriver, tighten the mounting screws. The wall
clamps will rotate as the screws are tightened. (
Caution
: Too
much force will cause the frame to warp and will damage the
speaker system.)
Stereo Installation
To change the speaker to an 8-ohm impedance for stereo, cut the white & black transformer leads, making sure
to leave enough wire to attach back together if needed. Strip wire leads going to crossover board about
¹⁄₄
” and,
using wire nuts, connect the white wire to positive and black to negative. The transformer can remain in the
cabinet without affecting the speaker operation.
Painting the Speaker System
The front of the DIN-100AT speaker may be painted to blend with any decor. For best results, these procedures
should be followed:
Use an aerosol spray paint containing a nitrocellulose lacquer for best adhesion. If using the same paint as
being used for existing walls or ceilings, the grilles should first be spayed with a suitable primer of nitrocellu-
lose material then painted with either an enamel or latex paint
2. Before painting plastic frame and grille, very lightly sand with fine sandpaper
3. Remove grille from frame and spray paint with aerosol paint, taking care to not to overpaint or
overbrush which will fill holes and limit the speaker’s performance
4. Before painting the plastic frame, cover the speakers in the cabinet
TECHNICAL SPECIFICATIONS
System
Power Handling
Frequency Response
Tweeter
Sensitivity
Woofer
Crossover
Dimensions
Adjust the direction of the tweeter toward the primary listening area.
Ported Two-Way In-Wall/Ceiling Speaker System
10
¹⁄₄
" W x 14
⁵⁄₁₆
" H x
3
¹⁄₂
" D
Weight
4 lbs. 12 oz.
100-Watt@8ohm, [email protected]; Continuous
45Hz-20kHz ±5dB
1.75" Pivoting with ±3dB Switch
93dB 1w/1m
Two Way
8" Polypropylene, 20 oz. Magnet
Transformer
Rotating wall clamps
DIN-100AT Back View
1.
1.
2.
3.
4.
5.
6.
Spring
clip
terminal
