J-Tech Digital JTECH-VWM90, Руководство пользователя

Страница: 5 / 22

5 | P a g e
A. RS232 Control Loop Out – Used in cascade mode to loop out RS232 commands to the next
device
B. Network Interface – TCP network protocol used for control system to issue instruction to control
the device (Default IP Address: 192.168.1.192 | Default Web Login Password: admin1 )
C. RS232 Input – Used to issue RS232 commands to the device
D. DIP Switch (Board ID) – Indicates the ID of the current device in cascade mode. For detailed
settings, see Note 1 below
E. IR Port – Used for receiving remote control signals. Needs external IR receiver
F, G, H, I – 4 HDMI input ports. Input Port “ I ” supports 4K@60Hz maximum resolution, while ports
“ F/G/H ” support maximum 4K@30Hz. The LED lights next to each HDMI interface indicates an
active signal input
J. 1 DP input interface. Supports 4K@60Hz
K. 3.5mm Audio out interface for external audio devices
L. DP local loop-out. When multiple devices are cascaded, this port acts as the DP input source for
other JTECH-VWM90 devices. The LED light next to this interface indicates that there is a loop-out
signal output
(In single screen mode, the loop-out follows the selection of the input source channel to switch. In
non-single screen mode, only the loop-out DP signal is supported)
M. Power switch
JTECH-VWM90 – rear panel
N. Power Interface – Connect to the provided 12V@2A AC-DC power supply. LED indicator next to
the interface is an indicator of the device receiving power
O - W. 9 HDMI output ports. The LED lights next to each HDMI interface indicates an active output
signal