J-Tech Digital JTD-190, Руководство пользователя

Страница: 10 / 14

-8-
7. ASCII Commands
The JTECH-18EX50 also supports ASCII command control. Connect the
SERVICE port of the product to a PC with a USB cable. Then, open a Serial
Command tool on PC to send ASCII commands to control the product.
The ASCII command list about the product is shown as below.
ASCII Commands
Serial Port Protocol - Baud Rate: 115200 | Data Bits: 8-bit | Stop Bits:1 | Check Bit: 0
x - Parameter 1
y - Parameter 2
! - Delimiter
Command Code Function Description Example Feedback Default Setting
Power
s power z!
Power on/off the device
z=0~1 (z=0 power off, z=1
power on)
s power 1!
Power on
System Initializing...
Initialization Finished!
FW version x.xx.xx
power on
r power! Get current power state r power! power on/power off
s reboot! Reboot the device s reboot! reboot
System Setup
help! List all commands help!
r type! Get device model r type! HDC-SPB18D60
r status! Get device current status r status!
Obtain power status,
in/out connection &
EDID mode
information
r fw version! Get firmware version r fw version!
MCU BOOT: Vx.xx.xx
MCU APP: Vx.xx.xx
r link in!
Get the connection status of
the input port
r link in!
HDMI IN: connect
r link out y!
Get the connection status of
the y output port
y=0~8(0=all, 1~8=CAT 1~8)
r link out 1!
CAT OUT1: connect
r link loop out y!
Get the connection status of
the y loop output port
|
y=1
r link loop out 1!
HDMI LOOP OUT:
connect
s reset! Reset to factory defaults s reset!
Reset to factory
defaults
System Initializing...
Initialization Finished!
FW version x.xx.xx