J. Perkins Panic, Инструкция по эксплуатации, Страница: 7 / 14

▢
29. With the battery tray in place, positioned so that the
ESC tray is located closest to the firewall, run some slow
cure glue along the mating surfaces. This is best done by
lifting one side up whilst the tray is in place, running the
glue along the edge, then pushing the plate back down to
locate on the pegs, before repeating the process on the
other side of the tray. Once completed the tray should be
located centrally over the pegs. With the tray securely glued
in position, cut the supplied triangular balsa stock and
reinforce the joints.
▢
30. Before installing the ESC check to ensure that its main
power lead is long enough to pass through the designated
hole into the battery tray area and is easily able to be
connected to the battery with the model’s wings attached. If
the lead is too short you will struggle to connect the battery.
Slide the ESC into its tray and poke the relevant cables out
through the hole in the firewall. Connect the cables and test
the motor direction. When you’re happy, draw the ESC
slowly aft, pulling the wires back through the hole. Push the
ESC forward again so the cables are bunched behind the
firewall and the ESC is correctly positioned. Pass a cable
tie through the vent hole, around the ESC tray and secure
the ESC to the tray.
WARNING! Double check that the ESC and cables are not
making contact with the motor or shaft.
▢ 31. Remove the film from the lifting tab fixture point and
the film from the battery hatch so the tab can be inserted.
Glue into place on the battery hatch.