Aqua Breeze™ Instructions Mobile II Cooling Fan
Initial Setup of the Unit:
1) After assembly: Remove the fan sub-assembly and hardware from the shipping carton.
a) The fan may be tilted to four separate positions by pulling the pin on the side of
the fan mount, tilting the fan to the required position and inserting the hitch pin.
b) DO NOT ATTEMPT TO ADJUST FAN TILT WHILE THE FAN IS RUNNING.
SERIOUS INJURY MAY OCCUR.
c) Connect the fan cord, finger tight, to the fan outlet near the top of the column.
2) Connect your water inlet hose (Not provided by J.E. ADAMS Industries, Ltd. to a
potable water source capable of delivering at least 1/2 gallon per minute of water at a
pressure not less than 20 Psig and not more than 125 Psig.
3) Important: The water source must be free of pressure surges caused by other
equipment. Pressure surges may cause air to become entrained in the water supply.
Running the pump under a dry condition will void the warranty on the pump
assembly.
4) Purchase an RV water pressure regulator locally to reduce the inlet water pressure to
50-55 Psig if your potable water pressure exceeds 125 Psig and install it at the
cooling fan water inlet.
5) The aqua-breeze-cooling fan is now ready for operation.
Operation of Unit:
1) Select an unobstructed location.
2) Connect the hose to the closed inlet shut-off valve and turn the source water on full
open.
3) Open the inlet shut-off valve slightly and eliminate all air from the hose. Close the
valve once the air is eliminated. Connect the inlet shut-off valve to the cooling fan
water inlet and open the valve
4) Select fan oscillation: 90
o
, 45
o
or 0
o
before operating the unit.
5) If the fan should be oscillating and is not oscillating, disconnect the electrical power
and hand tighten knob on top of the fan motor. Turn clockwise to 100 inch pounds. If
the unit still will not oscillate after restarting, the oscillator mechanism may need to be
replaced.
6) DO NOT ATTEMPT TO ADJUST FAN TILT WHILE THE FAN IS RUNNING.
SERIOUS INJURY MAY OCCUR.
7) The fan may be tilted in four positions by pulling the pin on the side of the fan mount,
tilting the fan to the required position and reinserting the pin.
