J.C. SCHWARZ JWS 2400PA, Руководство пользователя

Страница: 104 / 108

EN 104
AUXILIARY HANDLE
The auxiliary handle can be attached to
the auxiliary handle connector 6 on either
side or the top of the tool.
1
Screw the auxiliary handle into the ap-
propriate auxiliary handle connector 6 .
2
Using the Tool
1. Make sure your workpiece can not slip and
hold the tool firmly at the main handle 1 and
auxiliary handle 4 .
2. To switch on the tool, push the small lever
forward and then press the on / off switch 3 .
The tool will then be in lock on position.
3. Let the tool run at no-load speed for
about a minute and check if the in-
stalled wheel runs flawlessly.
Grinding:
The best grinding results can be
achieved with a 30° to 40° ap-
proach angle. Move the tool back and
forth with moderate pressure.
4. To switch off the tool, press and release the
on / off switch 3 .
Intended Use
The tool is intended for roughing and grinding of
metal and stone materials without the use of wa-
ter when equipped with a suitable grinding disc
and the appropriate guard.
For cutting the material mentioned above, a spe-
cial cutting guard (accessory) must be installed.
Any other use or modification to the tool is consid-
ered as improper use and could cause consider-
able dangers.
Warning! Make sure the tool is
switched off and unplugged.
Warning! For safe working conditions,
make sure the auxiliary handle is al-
ways mounted at the tool.
Product Overview
1 Main handle
2 Supply cord
3 On / Off switch
4 Auxiliary handle
5 Grinding guard
6 Auxiliary handle connector (3x)
7 Spindle lock button
8 Guard lock lever
9 Lower flange
10 Lock nut