Izzo Alex-2, Руководство пользователя

Страница: 22 / 25

Alex Espresso Machine
21
No Water From Hot Water Wand
 Make sure the main power switch has been turned on for at least 15 minutes.
 Check the upper gauge for steam pressure. Pressure should be about 1.2 bar. If the
gauge is at zero then refer to the “Not Heating” section of the troubleshooting manual.
If pressure is good then continue with steps below.
 Check the hot water knob for proper operation. Remove the end cap on the end of the
hot water knob. Check to make sure that the c-clip shown in the picture on the previous
page is attached.
Note: If the steam gauge shows normal pressure, but when you open the steam knob the pressure
immediately drops to zero then heats normally afterwards that is called a vapor lock. This is caused
by a sticking vacuum breaker valve. A replacement vacuum breaker valve can be purchased from
our website at the link below. http://www.chriscoffee.com/products/home/isomacparts/vbreakervalve
Not Heating
 Verify the machine is plugged into the outlet and the outlet has power.
 Make sure the main power switch has been on for at least 15 minutes.
 Make sure the water is turned on to the machine. If the water was off, then turn the
water back on. Turn the power switch off, unplug the machine and then wait 5 seconds
and then plug the machine back in and turn the power switch back on.
 Check the resettable hi-limit switch on the left side
of the boiler. With the machine unplugged firmly
press the red reset button shown in the picture
to the right.
 Check the PID settings to make sure it is
programmed as outlined in the PID section of
the owner‟s manual.