IXXAT Econ 100, Руководство по оборудованию, Страница: 16 / 22

Connections and displays
Pin no. X1300 Signal
1 +5 V
2 D-
3 D+
4 GND
Table 3-12: Pinout of the internal USB interface
3.4.2 Serial interface
The 4-pin X600 pin strip provides a serial interface with 3.3 V LVCMOS signal
levels. The power supply provided on the pin strip is not protected. The con-
nection pinout of the serial interface is shown in Table 3-13.
Pin no. X600 Signal
1 +3.3 V
2 TxD
3 RxD
4 GND
Table 3-13: Pinout serial interface
3.4.3 Battery
The battery provides the power supply for the real-time clock when the IXXAT
Econ 100 is disconnected from its main power supply. When changing the bat-
tery, be sure that a CR1632 3 V lithium battery is used that is suitable for op-
eration in the temperature range required.
3.4.4 JTAG connector
The X300 connector can be used to access JTAG on the Zynq component.
The connection pinout corresponds to the pinout of the "Xilinx Platform Cable
USB II" and is shown again in Table 3-14.
Copyright IXXAT Automation GmbH
16
IXXAT Econ 100 hardware manual,
version 1.3