iXsystems TrueNAS ES12, Основное руководство по настройке

Страница: 6 / 12

Support: 855-473-7449 or 408-943-4100 Email: support@ixsystems.com Page 4
3.3 Attaching Rails to the Rack
Chassis rails are configured to attach to round hole racks. Additional pins are included in the accessory kit to
configure the rails for square or 4mm hole racks. To reset the rails to fit a square or 4mm hole rack, unscrew
the pins at each end of the rails and replace them with the correct pins�
To secure a rail to the rack, open the clamp latches on the ends of each rail� Place the rail in the rack with the
front end toward the front of the rack, aligning the pins on both ends of the rail with the mounting holes in the
rack� Swing the clamp latch closed to hold the rail in place� Use two of the supplied screws to secure the back
end of the rail in place� Repeat the process for the second rail�
Caution: Two people are required to safely lift the chassis for rack installation or removal. Do not install
drives until after the chassis has been installed in the rack, and remove all drives before removing the chassis
from the rack� Carefully place the chassis onto the rails mounted in the rack� Push the chassis in until the ears
are flush with the front of the rack. If needed, attach the bezel. Use two of the supplied screws to secure each
ear to the rack�