iXBlue HYDRINS, Быстрый старт

Страница: 17 / 20

2016-02/MU/HYDRINS/AN/001/Ed. C
15
TROUBLESHOOTING
HYDRINS has a Built-In status and error Test (BIT) which raises alarms (through the color of the iXBlue Logo) and
displays messages in the HYDRINS User Interface.
If you encounter problems when installing or using HYDRINS, please refer to the following table.
If you still cannot resolve the problem, please contact IXBlue support (see previous page).
Symptom Possible causes Solution
Impossible to display the
Web-based User interface Incorrect URL address entered
in the Web browser Type in back the URL address
Default address is 192.168.36.1xx, xx
being the last two numbers of your
HYDRINS serial number.
Check computer IP address should be in
the same range as the unit.
The URL address has been
changed by another person 1) Retrieve the new HYDRINS IP address:
connect the repeater cable to your PC
and start a serial terminal
(Hyperterminal, BBTALK, etc.) configured
at 19200 baud, no parity, 1 stop bit, 8 data
bits. Reboot HYDRINS once connected.
You will get the HYDRINS boot sequence
message that contains its attributed IP
address (line beginning with “IFCONF”)
2) Enter this URL address in the Web
browser
The compass does not
display on the Web-Based
User Interface Flash player not installed on
the PC or its version is too old Install Flash player which is provided on
the CD-ROM