41
Boot Up NumLock Status
This field configures the numeric keypad after system booting up.
Options
Description
On (*)
Keypad works as number keys
Off
Keypad works as arrow keys
Floppy Drive Swap
When this field is enabled, the logical drive letter of floppy drive A and B will be hanged without
changing the physical cable.
Options:
Enabled
Disabled (*)
Floppy Drive Seek
When this field is enabled, BIOS will check floppy drive status during POST. If an error occurred,
system will be paused and an error message will be prompted.
Options:
Enabled (*)
Disabled
Floppy Access Control
This option specifies the read/write access that is set when booting from a floppy drive. The
settings are Read/Write or Read-Only.
Hard Disk Access Control
This option specifies the read/write access that is set when booting from a hard disk drive. The
settings are Read/Write or Read-Only.
PS/2 Mouse Support
Set this option to Enabled to enable AMIBIOS support for a
PS/2-type mouse. Pins 2-3 of the PS/2
Mouse Selector jumper on the motherboard must be shorted together to enable PS/2 mouse support.
The settings are Enabled or Disabled
Primary Display
This option configures the type of monitor attached to the computer. The settings are Mono,
CGA40x25, CGA80x25, VGA/EGA, or Absent.
Password Check
This option enables password checking every time the system boots or when you run AMIBIOS
Setup. If Always is chosen, a user password prompt appears every time the computer is turned on. If
Setup is chosen, the password prompt appears if AMIBIOS is executed. See the Advanced Setup
chapter for instructions on changing a password.
