IWILL VD133 Pro Series, Руководство пользователя

Страница: 26 / 80

26
VD133 Pro Series
Chapter 4 Haredware Setup
Chapter 4
Hardware Setup
4.1 Before Installation
For installation, you may need some or all of the following tools:
Medium size flat blade screwdriver
Medium size Phillips head screwdriver
A 3/16 inch nut driver or wrench
Users must follow these guidelines to ensure the motherboard is protected
during installation.
a. Make sure your computer is powered-off whenever working with inside
components.
b. The motherboard, like all other electronic equipment, is sensitive to
static. Please take the proper precautions when handling it. If possible,
ground yourself by touching a metal table or desk. keep the board in its
conductive wrapping until it is configured and ready to be installed in
your system.
c. Keep all magnets away from both your hard and floppy disk drives,
especially magnetic screwdrivers. Keep both floppy and hard disks
apart if disassembled.
d. Keep water and liquids away from your computer and its components.
4.2 Jumper setting
4.2.1 JP1 Clear CMOS jumper (CMOS)
To reset the CMOS data, you should turn off the computer first, take the JP1 jumper
cap off pins 1-2, place onto pins 2-3, and then place back onto pins 1-2 again. Then,
turn on your computer, press <Del> key during boot up and enter the BIOS setup
program to re-set your preferences.