2-20
2
2
.
.
4
4
.
.
2
2
.
.
F
F
l
l
o
o
p
p
p
p
y
y
D
D
i
i
s
s
k
k
D
D
r
r
i
i
v
v
e
e
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
This 34-pin connector supports the provided floppy disk drive
ribbon cable. After connecting the single end to the board, connect
the plug on the other end to the floppy drive.
34-pin FDD connector
Slim type FDD
connector
Pin 1
2
2
.
.
4
4
.
.
3
3
.
.
P
P
r
r
i
i
m
m
a
a
r
r
y
y
I
I
D
D
E
E
c
c
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
s
s
These two 40-pin IDE connectors support 40-wire IDE hard disk
ribbon cables (provided). After connecting the single end to the
board, connect the two plugs at the other end to your hard disk(s).
If you connect two hard disks to the same cable, you must
configure the second drive to Slave mode by setting its jumpers.
Refer to the documentation of your hard disk for the jumper
settings. BIOS now support IDE HDD or IDE CD-ROM boot-up (Pin
20 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 20 plugged in). Support for Ultra DMA
33/66/100 is also featured in the BIOS.
IMPORTANT
Ribbon cables should always be connected with the red stripe
on the Pin 1 side of the connector. IDE ribbon cables must be
less than 46 cm (18 inches) long, with the second drive
connector no more than 15 cm (6 inches) from the first
connector.
