Page 13 of 21
iWave Systems Confidential.
Telematics Control Unit Product User Manual
After successfully programming the binaries to the boot media, then progress bar will become green
colour and status box will be shown as “Done”.
Figure 15: Binary Programming Succeed
Click “Stop” to finish, and Click “Exit” to terminate the application.
After powering OFF the platform, change to internal boot mode (Remove the jumper if mounted).
3.3.1
Limitations
This application does not support USB 3.0 host port.
If MFG tool v2.0 application is executed on Windows7, when it runs in the “updater” phase, a pop-up
message will be shown to ask whether disk should be formatted. Please ignore it, or click the "Cancel"
button. It will not affect any function.
If you stop the application in between of programming binaries and if you re-start, the application will try
to continue from the point where you stopped before. But it is not guaranteed that it can continue
successfully. It is NOT recommended to do this.
Login Credentials of OBD2 Device
User name: root
Password: iWavesys123
3.4
Login to the Device Console using Serial board
Connect the Serial Debug Board to the Serial Debug port as shown in image (1) of Figure 9
Connect the one end of the USB Cable to the Serial Debug Board as shown in image (2) of Figure 9
Power on the Telematics control unit as described in Figure 8
Connect the other end of the USB cable to PC to view the Debug prints.
Open the Tera Term Tool available on the host PC and select the appropriate serial COM port as
mentioned in Figure 16