IWAKI PUMPS Hicera V Series, Инструкция по эксплуатации

Страница: 24 / 32

- 22 -
■ Dismantlement (V-15)
Follow the procedure below to take apart the pump head.
1. Remove all tube connections from the pump head.
Be careful not to get wet with chemical liquid. Wipe chemicals off immediately when your hand or compo-
nent parts get wet.
2. Remove the pump base (18) from a foundation.
3. Unscrew the pump frame mounting screw (23) and the hex socket head bolt (22) to separate the pump
frame (12) from the motor frame (13).
4. Unhook the plunger ass'y (1) from the drive joint ass'y (14).
5. Pull out the plunger ass'y (1) by rotating it in the cylinder (2).
Do not roughly withdraw the ass'y, or lip seals may be damaged.
6. Remove four pumphead mounting screws (24) on the pump frame (12) to separate the pump head (3).
7. Unscrew and take away all the tube joints (6) from the pump head (3).
8. Unscrew and remove all the four head cover mounting screws to detach the head cover (4) from the pump
head (3).
9. Withdraw the cylinder (2) from the pump head (3).
Clean all parts thoroughly after dismantlement.
10. Pull out the lip seals (11) and seal stopper (10) by rotating them slowly on the plunger.
Do not bend or scratch the lip seals. Clean all parts thoroughly after dismantlement.
Maintenance