IWAKI PUMPS Hicera V Series, Инструкция по эксплуатации

Страница: 21 / 32

- 19 -
■ Dismantlement (V-05/-10)
Follow the procedure below to take apart the pump
head.
1. Remove tube connections from the pump head.
Be careful not to get wet with chemical liquid.
Wipe chemicals off immediately when your hand
or component parts get wet.
2. Remove the base (13) from a foundation.
3. Release the lock lever (18) and direct the pump
head to 10 º position.
4. Loosen the hex sock head bolt (20) via the hole
beneath the base (13) and unfix the connection
between the pump head (3) and the mounting
plate (14).
5. Take out the pump head (3) from the drive joint
ass'y (103) with the cylinder and plunger (1) in it.
6. Remove the cap nut (4) from the pump head and
pull out the cylinder (2) with the plunger (1) in it.
7. Pull out the plunger (1) by rotating it in the cylin-
der (2).
8. Pull out the lip seals (8) by rotating them slowly
on the plunger.
Be careful not to damage lip seals. Clean all parts
thoroughly after dismantlement.
Maintenance