9
EN
Instruction manual
Initial operation
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
Switching On/Off
Before connecting the device to the electric power
supply, make sure that the main supply voltage is
230V/50Hz.
(PW-900)
Switching On
Put the mains plug in.
Switching Off
Pull out the mains plug.
(PW-1500)
Switching On
To switch the machine on, press the On/Off switch
(8) in “On” (I) position (1>750 W; 2>1500W).
Switching Off
To switch the machine on, press the On/Off switch
(8) in “Off” (O) position.
Operating instruction
WARNING: Handle the pipe welder with
care, holding only by the handle.
• Place the machine on the supporting board (6)
well.
• Install the matrix (5) to be used according to
specifications needed on to the heating board (4)
by means of the relevant screw.
fig.1
• Connect the device to the supply mains. When
you turn on the pipe welder for the first time, a small
quantity of smoke may come out. The reason is just
that come coating residues are being automatically
removed.
(PW-900)
•
Red indicator
shows the machine is
heating.
•
Green indicator
shows the machine has
stopped heating and the heating board
(4) has reached the temperature set on the
thermostat. Now the welding process can
be started.
(PW-1500)
fig.2
ON
:
HEATING
OFF
:
READY
• Cut the pipe perpendicularly to its axis. Be sure
to clean the pipe and fitting.
• Push the pipe and fitting into matrix for a few
seconds (see heating time on the table).
fig.3
• Pull them out rapidly and then insert the pipe
into the fitting without screw to the depth needed
steadily.
• Keep the two parts under pressure for a few
seconds. (See cooling time on the table).
