design and production by : Drake Enterprises Limited - Phone : 0118 986 8526
USEFUL INFORMATION ABOUT YOUR VEHICLE
CHILD SEATS
FUEL
IN CASE OF BREAKDOWN
DRIVER’S SEAT
Vehicle specifications are subject to change. When the engine is turned off, ensure that the starter switch is in position II when operating electrical items such
as door mirrors and windows, etc. This vehicle does not include any manufacturer handbooks or manuals.
No responsibility is accepted for inaccuracies or misunderstanding caused by the wording of this guide. If in any doubt ask a member of staff for assistance.
Use hazard lights. Attempt to park
in a safe position.
Use an emergency phone rather
than a mobile as emergency
services will then know the location
of the vehicle.
Never use a child seat in a front
passenger seat which is fitted with
an active airbag (SRS). Follow all
fitting instructions carefully.
Check seat positioning and security
before use.
VEHICLE INSTRUCTION CARD
TYRE PRESSURES (COLD)
CONTROLS
When parked, the handbrake should be fully
applied with the vehicle left in first or reverse
gear for vehicles equipped with manual
transmission or P (Park) for vehicles with
automatic transmission.
CAUTION!
NOTE: SHOULD THIS VEHICLE NOT
BE SUPPLIED WITH A SPARE WHEEL,
PLEASE REFER TO THE TELEPHONE
NUMBERS SHOWN ON THE TAX DISC
HOLDER.
For assistance after an accident/incident, please call 0800 0280 999
For assistance after a breakdown or help with tyres or windscreens please refer to the numbers on the tax disc holder.
3 SEATS
TAIL LIFT VAN
Key / remote control operated central dead locking. Depress the door locking knobs to lock the doors from the inside.
Remote anti-theft alarm. Passive arming of electronic engine immobiliser after removal of the key from the starter switch.
Use the handle to open. Vehicle is fitted with one (on left or right side) or two side sliding doors. Floor is fitted with fixed load
lashing rings for securing loads. Twin rear doors can open up to 270 degrees wide. Follow the instructions on page 2 of this
guide when using the tail-lift (if fitted).
Electric adjustment operated by the control pad on the driver’s door, or manual internal adjustment.
Electric front operated via control buttons on the driver’s door.
Ensure gear selector is in neutral (or N) and handbrake is on. Place ignition key in starter switch. Use a normal starting
routine. Select desired gear. Release handbrake and brake pedal and gently press the accelerator to move the vehicle.
Some vehicles may be fitted with automatic transmission (use A for fully automatic, and select M- or M+ to manually select
gears). Some vehicles may also be fitted with auto start-stop engines, whereby the engine shuts off when the gear selector
is in neutral and the vehicle is at a standstill. To restart just depress the clutch.
Located on nearside of vehicle. Centrally locked (or use key to unlock). Twist off the cap anticlockwise.
Pull bonnet release lever located in the passenger footwell. Unhook catch under bonnet.
The tools and jack are stored under the driver’s seat. The standard spare wheel is found slung underside the vehicle,
secured by a retaining bolt. Use the tools to undo the bolt, and lower the wheel to the ground. To change the wheel: move
the vehicle to firm / level ground. Turn the engine off, select first gear. Apply the handbrake. Loosen the wheel nuts by
turning them anticlockwise (do not remove them) before jacking up. Only use the specific reinforced jack points on the
underside of the vehicle. Fit the jack. Crank the jack to lift the vehicle. Completely loosen / remove nuts and wheel and
replace with the spare. Refit / tighten the wheel nuts. Lower the vehicle. Tighten the wheel nuts.
IF FITTED. Refer to the instructions on the second page of this guide.
IMPORTANT : please note that when unlocking the rear door shutter, the keys must be removed before raising the
shutters - as the keys can become broken or damaged if this instruction is ignored.
VIC-IVE-01 / 25-05-2016
Locking the doors?
Anti-theft system?
Loading cargo?
Adjusting door mirrors?
Opening the windows?
Starting the engine?
Opening fuel filler cap?
Releasing the bonnet?
How to change a tyre?
How to use the tail-lift?
Check tyre pressure regularly
Legal minimum tread depth is 1.6 mm
Confirm tyre pressures by consulting
reference table on driver’s door B-pillar.
1 Heating & Ventilation
2 Hazard Lights
3 Starter Switch
4 Headlights
5 Sidelights
6 Indicators
7 Wipers
8 Rear Screen Wipers
9 Horn
10 Bonnet Release
12 Rear Fog Lamp
13 Front Fog Lamp
10
3
1
12 / 13
2
4 / 5 / 6
9
7 / 8
9
R 1 3
2 4 6
5
1 3
2 4 R
5
or
M-
M+
A
N
R
or
IVECO DAILY VAN
3.5T LUTON 0.5T TAIL LIFT
FUEL
DIMENSIONS
Fuel Tank Capacity
litres
100
Vehicle Length
m
6.23
Vehicle Width
m
2.3
Vehicle Height
m
3.15
Cargo volume cu.
m
18
Cargo Length
m
3.95
Cargo Width
m
2.06
Cargo Height
m
2.19
Vehicle Weight (unladen)
kg
2625
Payload Weight
kg
875
Maximum Weight
kg
3500
DRIVER'S SEAT
FUEL
DRIVER'S SEAT
Tilt
Height
Only use the correct fuel type.
Refer to fuel filler cap labels.
Lumbar
Legroom
